• Make sure there is a trigger spring inside
the frame.
ERRATIC VELOCITY / RAIL™ WON’T FIRE
RAIL™ FIRES BUT BALLS ARE DROPPING OFF
OR NOT EVEN COMING OUT OF THE BARREL
• Make sure the battery is good.
• Raise the dwell to factory level (40).
• Make sure bolt is well lubed and moves well.
If there is too much friction in the Bolt, it will
cause the RAIL™ to shoot down.
• Make sure air system is screwed in all the way.
FIRST SHOT IS TOO HIGH
• Change the Seat inside the Hyper3™ regulator.
For disassembly instructions consult the
technical section.
• Try turning off the ABS feature by turning DIP
#1 to the off position.
VELOCITY IS NOT CONSISTENT
• Make sure the paintballs you are using fit the
barrel good and are consistent in size.
The stock barrel with the RAIL™ is .690 size.
You should be able to blow the paintball
through the barrel but they should not roll
through the barrel on their own.
• Remove the bolt kit and re-lube it. Change any
O-rings causing a lot of friction. Make sure
#014 O-ring in bolt tip is in place and in
good condition.
• Raise the dwell.
• Change the battery.
• Check that the Hyper3™ regulator is working
correctly and that the pressure is consistent.
A separate regulator testing tool is available
for this. If needed, disassemble and change
worn out O-rings in the Hyper3™ regulator.
OTHER CATEGORIES
DOUBLE FEEDING
• If you get two balls firing at once change the
ball detents by removing the Eye Pipe,
replacing the orange detent clip and
reinstalling the Eye Pipe.
BREAKING PAINT
• Make sure you use high quality paintballs and
that they are stored according to the
manufacturers instructions.
• Check that #14 O-ring on bolt tip is in place
and in good condition.
• Make sure your loader is working good and
that the rate of fire is not set higher than the
maximum feed rate of the loader.
• Check that the barrel you are using is not too
tight for the paintballs you are using.
• Check the condition of the ball detents.
TROUBLE SHOOTING GUIDE
W
W
W
.
P
R
O
T
O
P
A
I
N
T
B
A
L
L
.
C
O
M
27
