CT-3400 TW
Installation Guide
P.9
Once inside the programming centre, the installer has a selection of many different sub-
menus. Once you are in the programming centre, you have the option of the following
menus:
a)
Transmitter Programming …………………..
p. 10
b)
Programming Options…………………..…
p. 11
c)
Honk Horn Timing* (*if available) ………..…
p. 14
d)
Tach Programming …………………..………
p. 13
Remember:
You have up to 20 seconds, once the parking lights are on solid, to select a sub-
menu, Failure to do so will result in the module exiting the programming centre and the installer
will have to flash the hood pin once more.
The Programming
Assistance Button
(a.k.a. PAB)
The PAB is located on the
side of the Module. This
push button mimics the
Hood-Pin switch in order
to avoid having to get out
of the vehicle and
pressing the Hood-Pin
switch.
The PAB will
work only when the
hood is up.
Before Programming a Transmitter
The Transmitter is not delivered pre-programmed: it must be programmed after the wiring of
the Module is completed.
The Module has the ability to retain up to 4 different Transmitter codes; if a fifth Transmitter is
programmed, the code of the first Transmitter will be erased from memory.
How to Program the Transmitter
1.
FLASH
the Hood Pin Switch (see p. 8).
Before the 20 seconds have passed, turn the Ignition Key to the
IGNITION ON (RUN)
position
and then to the
OFF
position.
2.
Press and hold the
LOCK
button until the vehicle gives 5 flashes. The Module has
stored the Transmitter in its memory.
3.
Close the Hood, to exit.
Table 1
To program a Transmitter on the second vehicle for multi-car operation, you must press the
TRUNK
button (instead of
LOCK
or
UNLOCK
) in step 3 of the transmitter programming procedure:
How to Enter Programming Options Mode
The System is equipped with two custom Programming Modes, allowing the installer to
custom-fit the system according to the requirements of each vehicle. When getting into the
Programming Option Mode, the Parking Lights will flash once, twice depending on the option
you have entered. The unit will stay in Programming Mode until the Hood Pin-switch or the
