P. 16
Installation
Guide
CT-3400 TW
2.
Remove the ignition key and exit the vehicle.
3.
Lock the doors – the vehicle will go on running for the entire pre-programmed run time.
Caution:
Do not leave children or pets unattended in a vehicle running in Idle Mode!!!
Turbo Mode
When programmed, this option allows turbochargers to idle down: after the user leaves the vehicle,
the engine will keep running for 60 sec. and shut down.
Proceed as follows to activate Turbo Mode:
1.
With the engine already running press
LOCK
on the transmitter until the parking lights come
on.
2.
Remove the key: the engine will go on running.
3.
Exit the vehicle and close the door.
4.
Press the
TRUNK
button to lock the doors and shut down the engine after 60 sec. running in
Turbo Mode.
Cold Weather Mode
If Cold Weather Mode is activated, it will start and run the engine for 3 minutes every 2 hours (8 or
20 minutes for diesel engines). This will go on for a period of 24 hours.
To activate Cold Weather Mode:
Press
F
then
START/STOP
button for three seconds. The parking lights will flash 3 times. There will
be one (1) “BEEP” as a confirmation. The icon will be displayed.
To exit Cold Weather Mode, do any of the following:
a) Open
the
hood.
b)
Start the engine by remote.
c)
Turn the ignition key to the
IGNITION
ON
(RUN)
position.
d)
Place the vehicle into valet mode.
e) Press
F
then
START/STOP
buttons for 3 seconds.
To exit Cold Weather in Safe Start Mode:
Press
F
then
START/STOP
buttons for 3 second, the parking lights will flash once. The icon will
disappear.
Use Mode 2, Function 4, Option 1 to set a diesel engine to a 20-minute run time in Cold Weather
Mode. Option 3 will otherwise set a diesel engine to a 8-minute run time.
Ignition-controlled Door Locks
ON
by default (if remote door locks are installed). This feature will
LOCK
all doors when the brake
pedal is pressed while the ignition key is in the
IGNITION ON
(
RUN
)
position. The unit will
UNLOCK
all
doors when the ignition key is turned to the
OFF
position.
•
If the
Ignition Lock Only
Option is selected, the system will only lock the doors.
•
Ignition Unlock Only
is selected; the system will only unlock the doors (provided the
ignition key was in the
IGNITION ON
(
RUN
)
position and that the brake pedal was pressed
at least once).
Smart Rearm
The system will be rearmed only once. Extra rearm pulses will not be sent when
LOCK
is pressed
several times. (Certain factory alarms are affected when additional rearm pulses are sent once the
system is armed.)
