Pronar T683
SECTION 4
4.26
Rear load box wall is equipped with chute slide gate (1) – figure (4.6) and chute opening (2)
(optional equipment) which are used for unloading loose materials. Chute design allows very
accurate dosing of the material to packaging (sacks, boxes etc.). The opening gap can be
controlled using lever (3). In order to do that loosen the bolt interlocking slide gate (4), open
the slide as required and lock again using the bolt. When unloading through the chute do not
open wall locks or wall extension locks and tipping of the load box must be done very slowly
and without jerking. Raising the load box quickly will exert large pressure on the rear part of
the load box due to displacement of the carried material and could compromise trailer's
stability.
FIGURE 4.6
Chute
(1) chute slide gate, (2) chute, (3) lever, (4) locking bolt
The trailer can be additionally equipped with a folding side chute located on the left, right or
on both sides of the load box. Also, the trailer can be additionally equipped with a rear chute
Summary of Contents for T683
