PRONAR T683, Operator'S Manual, Page: 143 / 147

SECTION 5 Pronar T683
5.41
Set the drawbar eye in its new position and screw down with bolts (3) using
appropriate torque.
The faceplate design (2) allows 4 possible drawbar eye positions,
figure (5.11).
Check degree of drawbar tightening after first travel under load.
FIGURE 5.17 Adjustment of drawbar eye position
(1) drawbar with fixed eye, (2) faceplate, (3) nut and bolt connection
5.14 TROUBLESHOOTING
TABLE 5.5 Troubleshooting
FAULT CAUSE REMEDY
Brake system conduits not
connected Connect brake conduits (applies to
pneumatic systems)
Applied parking brake Release parking brake.
Damaged pneumatic system
connection conduits
Replace.
Leaking connections
Tighten, replace washers or seal sets,
replace conduits.
Problem with
moving off
Damaged control valve or
Check valve, repair or replace.