UltraTrak SX4000, SX8000 & RM8000 User Manual
16
Figure 11. Location of Password Reset Jumper on Controller Board
Assign a SCSI ID
Each device on a SCSI chain must have a unique ID. The default SCSI ID setting
of the UltraTrak is 0. If you need to change the SCSI ID setting of the UltraTrak,
do the following:
1. From the Idle mode display, press the
SEL
button on the front panel.
2. Press button once to select
Configuration
, then press
SEL
button.
3. Enter the password at the prompt (see Enter Password on page 15).
4. At
the
Configuration
menu, use the button to select
Configure SCSI
,
and then press the
SEL
button. (See page 60 for more details.)
5. At
the
Configure SCSI
menu, use the button to select the
SCSI ID
, and
then press the
SEL
button. (See page 62 for more details.)
6. At
the
SCSI ID
menu, use the and button to select the SCSI ID
number, and then press the
SEL
button. (See page 62 for more details.)
7. Press
the
EXIT
button until you return to the
Idle
mode. (See page 36 for
more details.)
