Chapter 2: Getting Started
15
Enter or Change the Password
You are prompted for a password each time you access the UltraTrak
Configuration Mode. A password consists of four digits. The default password is
0000.
Enter Password
You are prompted to enter the correct password each time you access the
UltraTrak Configuration mode.
Please Enter Password:
0 0 0 0
The active password digit is marked by an
underscore.
Password entry begins with the left-most digit. You must enter the proper value before
proceeding to the next digit. You change the value of the active password digit by pressing
either the button or the button. The button increments the digit downward (as, 0,
9, 8, 7 …). The button increments the digit upward (as, 0, 1, 2, 3 …).
Press the
SEL
button to proceed to the next digit or to submit the password if you
have just entered the last digit. You are given access to the
Configuration
menu
if you entered the password correctly.
Change Password
You may change the password by doing the following procedure:
1. From the Idle mode display, use the button to select
Change Password
.
2. Press
the
SEL
button.
3. Enter Old Password.
4. Enter New Password.
5. Press
Exit
at the
New password saved
prompt.
Reset to Default Password
You can reset the password back to its default value of 0000 by momentarily
shorting pins 1 and 2 of the Password Reset Jumper located on the controller
board. See Appendix E: Replacing the Controller Card at the end of this manual
for information about accessing the controller board.