Chapter 2: Installation
7
Installing the FastTrak Card
The FastTrak RAID Controller card fits into any available:
•
32-bit PCI slot (must be PCI 2.2 compliant)
•
The 32-bit portion of a 64-bit PCI slot
on the PC’s motherboard (see Figure 1 below).
1.
Remove the cover of your system.
2.
Remove the inside slot cover of an available 32-bit PCI slot on the
motherboard.
Note: FastTrak SX4030 supports only a 33-MHz PCI slot.
3.
Install the FastTrak card into the open slot (above). Secure the bracket to the
system’s frame.
4.
Attach your system case’s 2- or 4-pin LED cable to the LED connector on the
FastTrak card (see Figures 2 and 3, below). Make sure that pin 1 on the
connector is aligned with pin 1 of the cable.
5.
Fasten the FastTrak card bracket to the system case (see below).
