44
promesstec GmbH
I Niedersachsenstraße 4 I D- 48465 Schüttorf I Tel.:+49 (0)5923/ 90 229 0 I Fax:+49 (0)5923/ 90 229 29
E-Mail: [email protected] I Internet: www.promesstec.com
4. Commissioning and operation
4.1 Before mounting
Check whether a completely assembled transmitter has been
supplied.
Inspect the device for any damage that may have occurred during
transport. If such damage is present, notify the carrier and supplier
immediately.
Keep the packaging, as it provides optimum protection during
transport.
Make sure that the housing and the connection contacts are not
damaged.
4.2 Mouning / Installation / configuration
• Very low power consumption means units can be mounted side by side without
an air gap - even at 60°C ambient temperature.
• Configuration, monitoring, 2-point-prozess calibration and more are
accomplished using UMU-FD detachable display.
• All programming can be password-protected.
Calibration and adjustment
During calibration and adjustment, the measuring and connection of external voltages
must be carried out according to the specifications of this manual. The technician
must use tools and instruments that are safe to use.
Normal operation
Operators are only allowed to adjust and operate device that are safety fixed in pa-
nels, etc., thus avoiding the danger of personal injury and damage. This means there
is no electrical shock hazard, and the device is easily accessible.
