40
promesstec GmbH
I Niedersachsenstraße 4 I D- 48465 Schüttorf I Tel.:+49 (0)5923/ 90 229 0 I Fax:+49 (0)5923/ 90 229 29
E-Mail: [email protected] I Internet: www.promesstec.com
Warning!
A dangerous situation may possibly occur, which can lead to burns
due to hot surfaces or liquids if they are not avoided.
Warning!
The device is desgined for connection to hazardous electric voltages.
Ignoring this warning can result in severe personal injury or
mechanical damage. To avoid the risk of electric shock and fire, the
safety instructions of this guide must be observed and the guidlines
followed. The specifications must not be exeeded, and the device
must only be applied as described in the following. Prior to the
commissioning of the device, this installation guide must be examined
carefully. Only qualified personnel (technicians) should install this
device. If the equipment is used in a manner not specified by the
manufacturer, the protection provided by the equipment.
Warning!
Until the device is fixed, do not connect hazardous voltages to the
device. The following should only be carried out on a disconnected
device and under ESD safe conditions:
General mounting, connection and disconnection of wires.
Troubleshooting the device.
Warning!
To keep the safety distances, the relay contacts on the device must
not be connected to both hazardous and non-hazardous voltages at
the same time.
Warning!
Do not open the front plate of the device as this will cause damage to
the connector for the display/ programming front UMU-FD. The device
contains no DIP-switches or Jumpers. The device must be mounted
on a DIN rail according to DIN 60715.
