Promega Corporation ·
2800 Woods Hollow Road
·
Madison, WI 53711-5399 USA
·
Toll Free in USA 800-356-9526
·
Phone 608-274-4330
·
Fax 608-277-2516
· www.promega.com
Printed in USA.
Part# TM274
Revised 6/08
Page 29
8. Once the anchor is loose, slide the
shipping anchor (C) down the linear slide
to fit snugly against the top of the plunger
bar. Retighten the shipping anchor (C)
against the plunger bar.
5188T
A
C
9. By hand, gently lower the magnetic rod
assembly down as far as it will go. The
bottom of the magnetic rods should be
pressed into the foam packaging material
that is sitting on top of the platform.
10. Locate the shipping anchor (B) at the top
of the linear slide.
5187TB
B
11. Use the 1.5mm Hex Wrench to loosen the
screw in the middle of the shipping anchor
(B). Do not completely unscrew the anchor
from the linear slide.
12. Once the anchor is loose, slide the
shipping anchor (B) down the linear slide
to fit snugly against the top of the plunger
bar. Retighten the shipping anchor (B)
against the plunger bar.
5186TB
tm274.0608.qxp 6/4/2008 9:56 AM Page 29
