REHATEAM s.r.l.—vicolo Negrelli
5
—
31040
Castagnole di Paese TV
-
www.rehateamprogeo.com
Service Manual JOKER JUNIOR 2.0 23
SERVICE MANUAL
SEAT DEPTH
To change the position of the support
A
, remove both nuts and washers
B
that are fixed to the bolts
C
.
Swing the backrest down to get access to both bolts
C
, then screw them off (the holes of the supports
A
are threaded holes).
Warning: if you remove only one nut and then try to unscrew the corresponding bolt, this bolt may result particularly hard to unscrew be-
cause the second one, still tightened with the nut, can create a pressure on the first.
Repeat the same operation on the other side of the wheelchair. The backrest remains fixed to the supports
A
.
Move the support and align its holes with those on the frame. The holes interval is 25 mm.
The seat depth adjustment is possible by moving the backrest support
A
; such support integrates the armrest support.
Insert one bolt and screw it until its head comes off the opposite side a little bit.
If the point of the bolt is not aligned with the exit hole, do not force screwing, but gently move the support until you reach the alignment.
Insert the other bolt and screw it all the way down.
Now, screw the first bolt, too, all the way down.
Finally, insert washers and nuts
B
and screw them while holding the bolts
C
.
As standard, the wheelchair is provided with a seat canvas one size longer (2.5 cm) than the seat depth PS requested on the order form.
For instance: requested PS = 32.5 cm; real PS = 32.5 cm; seat canvas = 35 cm.
Picture 1, standard assembly: you can see that the line of
the backrest is more 2.5 cm forward than the rear side of
the seat canvas.
Picture 2, the supports have been moved back by one
position (2.5 cm): the line of the backrest is at the same
level of the rear side of the canvas.
Picture 3 the supports have been moved back by another
position (2.5 + 2.5 cm): the line of the backrest is 2.5 cm
behind the rear side of the canvas.
A
A
B
C
C
B
C
1 2 3
