REHATEAM s.r.l.—vicolo Negrelli
5
—
31040
Castagnole di Paese TV
-
www.rehateamprogeo.com
Service Manual JOKER JUNIOR 2.0 16
SERVICE MANUAL
REMOVABLE SIDE GUARD
SIDE GUARD MODIFICATION
If one, the other or the combination of both adjustment above mentioned are not satisfactory, you can modi-
fy the side guard. Every side guard is shaped to measure according to the configuration of the wheelchair
when originally assembled. The shape of the side guard always allow for a reasonable good range of adap-
tation. Note: if the side guard is straight, you can decide to modify it or not.
A
When you decrease the rear height
, you have to move the side guard up.
At each adjustment, spread some mild
lock thread glue on the bolts
C
and
H
.
H
D C
3
2
1
3
1 2
1. Remove the three bolts
H
to take the side guard off the blade.
2. Position the side guard at approximately 5 mm from the tyre, always leant on the blade
A
. The bolt
C
on the blade must be inserted in the
hollow
D
of the support.
3. While holding this position, mark the point where it is necessary to drill the first new hole (1 or 2; 3 is usually not accessible with the rear
wheel on).
4. To do so, use a point and let it through the accessible hole. If the rear height adjustment is remarkable, you may need a new sideguard.
5. Drill a 5 mm on the sideguard where you have marked it.
6. Countersink the hole.
7. Insert and screw the bolt
H
.
8. To drill the second hole on the side guard, follow instruction from 3 to 7.
9. To drill the third hole, remove the side guard, mark the point where to drill and follow instruction from 5 to 7.
Advice for drilling.
While drilling a hole, such hole may result slightly moved with respect to the precise point you marked. For the first hole,
that move does not cause any trouble. On the other hand, for the second and third hole, it may cause a non-alignment between hole on the
side guard and hole on the blade. A good method to be more precise, once you reach point 5, is to use a 4 mm drill pin (in order to avoid
damaging the thread of the hole on the blade) and drill the side guard. Then, use and let a M5 tap through the threaded hole of the blade
and out of the side guard.
B
When you increase the rear height
, you have to move the side guard down.
X
B
If the lower side of the side guard is in contact with the support, it is necessary to cut it.
Measure the distance
X
from side guard and tyre and subtract 5 mm (es: 18-5 = 13 mm to cut).
Remove the three bolts
H
to take the side guard off the blade.
Draw the cut line according to the result you got.
Saw the side guard along the drawn line and round off the edges with a scissors blade or thin sand paper.
Continue with instruction
A
.
C
When you change the setting
, you have to move the side guard frontward or backward according to the new position of the rear
wheel, but the height of the side guard remains the same.
Proceed with instruction
A
.
D
When you change both the rear height and the setting
, you have to move the side guard up or down
and
forward or backward.
Continue with instruction
A
and, if necessary, instruction
B
, too
