REHATEAM s.r.l.—vicolo Negrelli
5
—
31040
Castagnole di Paese TV
-
www.rehateamprogeo.com
Service Manual JOKER JUNIOR 2.0 17
SERVICE MANUAL
REMOVABLE ARMREST
At each adjustment, spread some mild
lock thread glue on the bolts
C
and
H
.
B
A
C
A
B
V
You can adjust this armrest in height and depth
HEIGHT ADJUSTMENT
The blade
A
has, in its vertical part, a series of holes where to screw the bolt
C
. This bolt engages into the hollow
D
of the support
B
. There-
fore, to change the height, just remove the bolt
C
and screw it in another hole.
If you need to lower the armrest, the side guard could touch the support
B
and thus impede the adjustment. In such case, it is necessary to
cut the lower side of the side guard. Remove the two bolts
V
and draw a line where to cut the side guard where necessary or just above.
Saw the side guard along the line and round off the edge with a scissor's blade or with fine sand paper. Assemble the side guard.
WARNING: do not tighten the bolt
C
and
V
excessively: it may damage the threaded hole until making it unusable
.
HORIZONTAL ADJUSTMENT
Follow the instructions of the adjustment sheet “
removable side guard
”.
SIDE GUARD MODIFICATION
: should you want or need to change position of the side guard,
remove the two bolts
V
.
1. to move it frontward or backward, position it where you wish and, using one of the holes on
the blade, mark the point where to drill the first hole. If one of the two existing holes on the
side guard is usable, skip point 2 and 3.
2. Drill a 5 mm hole where you have marked.
3. Countersink it.
4. Insert and screw the bolt
V
.
5. Check the position of the side guard and mark the point where to drill the second hole.
6. Remove the side guard.
7. Drill the hole and then countersink it.
8. Assemble the side guard with the two bolts
V
.
9. If you need to move the side guard up or down, follow the same instructions, or, in some
cases, you may use the same holes of the side guard and fix it to other holes on the blade.
V
Follows next page
