REHATEAM s.r.l.—vicolo Negrelli
5
—
31040
Castagnole di Paese TV
-
www.rehateamprogeo.com
Service Manual JOKER JUNIOR 2.0 9
SERVICE MANUAL
REAR HEIGHT
STANDARD REAR UNIT
When decreasing the rear height it is necessary to remove the mudguard or the armrest first, fact,
the tyre will touch it and it will impede the adjustment.
If the side guard is straight, leave it where it is.
Loosen the grab screw
B
on the rear lower side of both clamps
A.
Loosen the bolt
C
of both clamps
A
.
Now you can slide the two clamps
A
along the posts
E
.
Should the clamps be hard to slide, loosen the bolts B and C and/or, with care, hit them with a
mallet to the necessary direction. Such operation may result particularly useful for the final adjust-
ment when the necessary movement is very little.
The rear axle
D
always remains fixed to the clamps
A.
The grab screw
X
and the bolt
Y
are not involved is this adjustment.
Slide the system to the necessary height.
Fix the clamp
A
of either side, tightening the bolt
C
hard and then tighten the grab screw
B
.
Before fixing the other side, check the height is the same.
To make sure that right and left side are at the same height, take measure from two “fix points”, for
instance: the straight line from the upper side
1
of the clamp
A
to the line
2
of the holes of post’s
plate that fixes the frame or to the line
3
of the upper side of the same plate.
When changing the rear height it is necessary to modify the mudguard. However, if the side-guard is
straight you may leave it as it is, its upper edge will be lower or higher with respect to the tyre.
To remove and adapt the side guards, follow instruction of sheet
“
side guard adjustment
”.
In presence of anti-tipper support, the bolt
C
is different; in fact, it is involved in the support’s assem-
bly. To proceed with the height adjustment, remove the nut
G
, loosen the two bolts
H
and move the
support away from the bolt
C
.
Now you can loosen the bolt
C
and continue the adjustment as above explained.
To re-assemble the support, slide it in along the bolt
C
choosing the one of the 4 holes and check which one give you the best inclination
of the anti-tipper. Then fix it with the nut
G
and finally tighten the two bolts
H
.
Remember that the rear height adjustment can affect the seat inclination, thus, it is necessary to check and adjust the fork angle.
It is advisable to spread a drop
of mild lock thread glue on the
on the grab screws
B
.
C
G
H
H
B
X
E
C
Y
A
D
A
3
2
1
A
