REHATEAM s.r.l.—vicolo Negrelli
5
—
31040
Castagnole di Paese TV
-
www.rehateamprogeo.com
Service Manual JOKER JUNIOR 2.0 21
SERVICE MANUAL
FOOTPLATE
ANGLE ADJUSTMENT
Raise the plate backward
The arms
G
allow for raising the plate, but they are not involved in the angle adjustment.
The clamp
H
is the component that allows for angle adjustment.
Loosen the two headless bolts
I
and the four bolts
L
.
With one or two hands, turn the clamp to the desired inclination.
Swing the plate down and let it rest on the clamp to check its inclination.
If you need more inclination, repeat the steps you made so far.
If you need less inclination, you can now simply push the plate down until the desired inclination.
Finally, tighten the bolts
L
first and then the headless bolts
I
.
G
G
H
L I L L I L
M
M
The provided foremost position of the plate is given when you fix it through its holes 1 and 4 and those of the arm
G
2 and 5.
Do not position the plate more forward than the provided foremost position: the plate will not lean over the clamp below.
To obtain the provided foremost position of the plate, you have to fix the plate through its holes 1 and 4 and the arm’s
G
2 and 5.
Do not position the plate more backward than the provided foremost position: the points of the arms
G
will lean out of the plate.
Note: between the foremost and the rearmost positions, there are 6 cm.
1
2
3
4
1
2
3
1
3
G
4
1
4
2
5
G
DEPTH ADJUSTMENT
1) Arms positioning
The plate is fixed to the rotation arms
G
with four bolts
M
.
The plate has six pre-drilled holes, whereas, the arms have five pre-drilled
holes.
To change the position of the plate, remove the four bolts
M
.
Move the plate frontward or backward to the new position.
Insert and fix the four bolts
M
positioning them, as long as it is possible, far
from one another.
Follows next page