BIW1A
series
~47~
User
Allows you to set each mode individually.
Defined
When not disabled, each of the ranges are from I min. to I
hr. except for HDD Power Down which ranges from I to
15min. and disable
If you would like to use Software Power-off Control function, you cannot
choose" Disabled "here, and should select "Yes" in PM Control by APM.
Video Off Method
Default: DPMS
This determines the manner in which the monitor is blanked.
V/H SYNC+ Blank
This selection will cause the system to turn off the
vertical and horizontal sync. ports and write
blanks to the
video buffer
Blank
This option only writes blanks to the
Screen
video
buffer
DPMS
Initial display power management
signaling
Video Off In Suspend
Default: Yes
This determines the manner in which the monitor is blanked.
Suspend Type
Default: Stop Grant
Select the Suspend Type.
The choice: PWRON Suspend, Stop Grant.
MODEM Use IRQ
Default: 3
This item determines the IRQ in which the MODEM can be used.
The choice: 3,4,5,7,9, 10,11,N/A.
Suspend Mode
Default: Disable
If you have selected User Define for the Power Management item, you can
set this item to a selection of timeouts from 20 seconds to 40 minutes.
HDD Power Down
Default: Disable
When enabled and after the set time of system inactivity, the hard disk drive
will be powered down while all other devices remain active.
Soft-off by PWR-BTTN
Default: Instant-off
Under ACPI (advanced configuration and power interface) the system can be
turned off mechanically (by the power button) or it can undergo a software
power off. If the system has been turned off by software, the system can be
resumed by a LAN, MODEM or ALARM wake up signal. This item allows
you to define a software power off using the power button. If the value is set
to Instant-Off, the power button will automatically cause a software power
