BIW1A
series
~45~
POWER ON Function
Default: BUTTON ONLY
The Power On Function item allows you to power on the system by pressing
hot-keys. If you set this item to Hot Key, you can use the item Hot Key
Power On to choose which hot keys are installed.If you set this item to
Password, you can use the item KB Power On Password to choose which
password are installed.
Onboard FDC Controller
Default: Enabled
This item will enable or disable the floppy disk controller.
FDC Write Protect
Default: Disabled
To enable/disable the write protection of floppy.
Onboard Serial Port 1/Port 2
Default: 3F8/IRQ4
Select an address and corresponding interrupt for the first and second serial
ports. Note : Set to Auto is not recommended.
UART Mode Select
Default: Normal
This lets you select the Infrared mode. Choices are Standard, HPIR, and
ASKIR. If you choose BPIR or ASKIR mode, the screen will show another
two lines to let you choose 'IR Function Duplex' (Full or Half) and “ RxD
TxD Active” (Hi Lo; Lo Hi; Hi Hi-,Lo Lo).
Onboard Parallel Port
Default: 378/IRQ7
This item lets you disable the built-in parallel port, or enable it by assigning
an 1/0 address and an Interrupt Request Line (IRQ).
EPP Mode Select
Default: EPP1.9
Select EPP mode for the port.
ECP Mode Use DMA
Default: 3
Select a DMA channel for the port. Choices are 3, 1.
