Processor Technology Sol-PC, Manual

Page: 60 / 284

PROCESSOR TECHNOLOGY CORPORATION
Sol-PC SINGLE BOARD TERMINAL COMPUTER
TM
SECTION III
( ) Step 41. Install the following IC’s in the indicated loca-
tions. Pay careful attention to the proper orientation.
NOTE
Dots on the assembly drawing and PC board
indicate the location of pin l of each IC.
IC NO. TYPE
( ) U65 74LS253
( ) U66 74LS253
( ) U78 74LS253
( ) U79 74LS253
( ) U93 74LS175
( ) U106 74LS175
( ) U70 74LS109
( ) Step 42. Turn monitor on, apply power to Sol-PC and perform
the test described in Step 40, except ground ~in S of U75 in-
stead of pin 2. You should get the same results.
( )If the test fails, determine and correct the cause before
proceeding with assembly.
( )If the Sol-PC passes this test, turn monitor and power
supply off, disconnect power cable and proceed to Step 43.
( ) Step 43. Install the following resistors in the indicated
locations. Bend leads to fit distance between mounting
holes, insert leads, pull down snug to board, solder and
trim.
LOCATION VALUE (ohms) COLOR CODE
( ) R13 1.5K brown-green-red
( ) R14 1.5K “ “ “
( ) R15 1.5K “ “ “
( ) R60 1.5K “ “ “
( ) Step 44. Using two 4-40 x 5/8 binder head screws, two #4
insulating washers, two lockwashers and hex nuts, install
30-pin right angle edge connector in location J5. Insert
screws from back (solder) side of board and place an insu-
lating washer on each screw on front (component) side of
board. Position connector with socket side facing right,
place over screws and seat pins in mounting holes. Then
place lockwasher on each screw, start nuts and tighten.
Solder pins to board.
Rev A III—30