Processor Technology Sol-PC, Manual

Page: 213 / 284

V. SUBROUTINES (cont.)
JUMP TABLE
Address Label Length Function
C000 START 1 This byte allows power-on reset of SOLOS. It
is 00 for SOLOS and 7F for CUTER, providing
an easy means of differentiating the exact
operating system in use.
C001 INIT 3 This is a "JMP" to the power-on reset.
C004 RETRN 3 Enter at this point to return control to
SOLOS command mode processor.
C007 FOPEN 3 Enter here to open a tape file.
C00A FCLOS 3 Enter here to close a tape file.
C00D RDBYT 3 Enter here to read a byte from an open tape
file.
C010 WRBYT 3 Enter here to write a byte to an open tape
file.
C013 RDBLK 3 Enter here to read one tape block into memory
based on a header.
C016 WRBLK 3 Enter here to write one tape block from
memory based on a header.
C019 SOUT 3 Enter here to output the character in
register "B" to the current system output
pseudo port. This is always an "LDA"
pointing to the byte containing the current
system output pseudo port value.
C01C AOUT 3 Enter here to output the character in
register "B" to the pseudo port specified in
register "A".
C01F SINP 3 Enter here to obtain status/character from
the current system input pseudo port into
register "A". This is always an "LDA" to the
byte containing the current system input
pseudo port value.
C022 AINP 3 Enter here to obtain status/character from
the input pseudo port specified in the "A"
register. On return, register "A" will con-
tain the character with the flags set to
indicate whether a character is present or
not.
16