assembly arm and rack move as one around
the column.
3. Tilt the table by loosening the bevel table
locking screw, removing the alignment pin
and tilting to the required angle (Fig. 11).
a. A scale is provided on the arm measured
in degrees to assist in setting the
required angle. For all normal operations
the table should be set at 0° (Fig. 12).
b. When the table is angled/tilted, ensure
the workpiece is clamped to the table.
4. To ensure that the drill is entirely
perpendicular to the table, insert a piece of
straight round bar in the chuck, place a
square on the table and bring it up to the
round bar. Adjust the table tilt if necessary so
that the table is correctly aligned.
5. Turn the table about its axis by loosening the clamp.
The table is capable of moving in four directions.
QUILL SPRING ADJUSTMENT
The quill return spring tension may cause the quill to return too rapidly
or too slowly.
1.
Adjust the spring tension by loosening the
front nut (Fig. 14-3) and the rear nut (Fig.
14-2) only enough to free the housing (Fig.
14-4) from the boss (Fig. 14-1). Make sure
that the spring housing (Fig. 14-5) remains
engaged with head casting.
2. While firmly holding the spring housing, pull
out the housing and rotate it counter-
clockwise to increase or clockwise to
decrease the spring tension until the boss
(Fig. 14-1) is engaged with the next notch on
the housing.
Fig. 11
Fig. 12
Fig. 13
9028002
VARIABLE-SPEED FLOOR-MOUNT DRILL PRESS
V1.0
Assistance available at www.princessauto.com or 1-800-665-8685
Page 14
