the feed handles to press the spindle
and chuck into place.
OPERATION
INSTALLING A DRILL BIT
1.
Insert the drill bit into the jaws of the chuck
approximately 1 in., ensuring that the jaws do
not touch the flutes of the drill bit.
2. Before tightening the chuck, ensure that the drill bit is centered
within the jaws.
3. Tighten the chuck securely with the included chuck key.
MORSE TAPER DRILL BIT
Remove the chuck and arbor to use morse taper drill bits.
1.
Raise the work table until it is about 3 in. (75 mm) below the chuck.
Place something soft on the table or have someone ready to catch
the arbor and chuck as they fall.
2. Rotate the spindle by hand to line up the spindle and the long slot
on the right side of the drill press, called the quill key hole.
3. Place the chuck tool in the quill key hole and lightly tap until the
arbor and chuck fall out.
4. Place Morse taper drill bit into the spindle, twist and push upwards
until bit is snug. Place a block of wood on the table and crank up
table until the tapered bit is firmly seated into the spindle.
ADJUSTMENTS
1.
Raise or lower the table by loosening the arm
locking handle and turning the crank:
clockwise to raise and counterclockwise to
lower (Fig. 10).
2. Swivel the table about the column by
loosening the arm locking handle. The table
Fig. 9
V1.0
VARIABLE-SPEED FLOOR-MOUNT DRILL PRESS
9028002
Page 13
Assistance available at www.princessauto.com or 1-800-665-8685
Fig. 10
