ASSEMBLE THE DRILL HEAD
1.
Loosen the set screw on the left-hand side of
the drill head assembly.
2. Slide the head assembly onto the column.
Position the drill head so the set screw is on
the left-hand side and the column's rack is on
the right-hand side. Tighten the set screw
(Fig. 5).
3. Screw each of the three feed handles into the
handle case until hand-tight (Fig. 6).
4. Screw the speed adjusting handle into the
handle case on the head assembly's left-
hand side (Fig. 7).
5. Open the chuck jaws to their maximum using
the chuck key.
6. Ensuring the chuck and spindle are
thoroughly clean, dry and burr free. Insert the
taper spindle's round end firmly into the
chuck.
7.
Insert the other end of the taper spindle, with
the chuck now attached, into the end of the
main spindle, turning to ensure that the point
on the end of the arbor locates correctly with
the drive slot in the spindle shaft (Fig. 8).
8. Secure the chuck and taper spindle using
one of the following methods:
a. Tap the chuck firmly with a wood mallet
to secure it in place. Hold a piece of
wood against the chuck and strike that
instead when using a metal mallet or
hammer (Fig. 9).
b. Move the work table upward as far as
possible. Place a piece of wood on the
table to protect the chuck. Pull down on
Fig. 5
Fig. 6
Fig. 7
Fig. 8
9028002
VARIABLE-SPEED FLOOR-MOUNT DRILL PRESS
V1.0
Assistance available at www.princessauto.com or 1-800-665-8685
Page 12
