19
ADJUSTING THE REED SWITCH
If the console does not display correct feedback, the
reed switch should be adjusted.
To adjust the reed switch, the right pedal and the right
shield must be removed.
First, lift the right link arm off the right pedal or the right
lock rods and move it clear of the right shield.
Next, see assembly step 4 on page 7 and
remove the Right Pedal (71) from the Right Crank
Arm (79).
Then, see the EXPLODED DRAWING on page 23.
Remove the six M4 x 15mm Tek Screws (22) from the
Left and Right Shields (46, 70). Then, gently pull the
Right Shield away from the Left Shield.
Locate the Reed Switch (6). Turn the Right Crank
Arm (79) until a Magnet (50) is aligned with the Reed
Switch.
Loosen, but do not remove, the M4 x 15mm Tek Screw
(22). Then, slide the Reed Switch (6) slightly closer
to or away from the Magnet (50), and retighten the
Screw. Turn the Right Crank Arm (79) for a moment.
Repeat these actions until the console displays correct
feedback. When the reed switch is correctly adjusted,
reattach the right shield and the right pedal.
79
22
6
50
