III.- INSTALLATION:
The Mixer-grinder is ready to use. Before to install the mixer-grinder, you only need to verify the next points:
1. Electrical installation meets the required specification of the equipment.
2. Place has an adequate illumination and leveled floor.
3. Room is clean and meets with the hygienic conditions for food process
3
MIXER GRINDER
KMG-32
II.- UNPACKING:
While unpacking the mixer-grinder take special care in removing the components and make sure that all are accounted for and
check possible shipping damage:
*Note: for reference numbers see
“Mixer-Grinder diagram for components” (central pages).
The grinding unit includes:
Item
Description
QTY
item
Description
QTY
1
Headstock support
1
8
Mixing blades
1
2
Headstock
1
9
Mixing blades shaft
1
3
Nut
1
10
Headstock Gasket
1
4
Worm
1
26
Mixing blades spacer
1
5
Blade or knife
1
27
Deflector
1
6
Plate
1
28
Footswitch (some models)
1
7
Ring
1
22 & 22
Casters
4
IMPORTANT!:
Wash the unit before using for the first time, specially the grinding unit and inside the hopper. Also
use the included food grade mineral oil to lubricate the plate (6) and knife (5)
–See Cleaning section
for more details.
How to remove Grinding Unit .
1.- Remove the ring (7) from the headstock (2) by rotating counterclockwise.
2.- Pull out the plate (6), the knife (5) and worm (4).
3.- Using both hands, turn counterclockwise the nut head (3) and then remove it. After this, pull out the headstock (2) from the
headstock support (1).
How to remove Mixing Unit (You need to release the latch system Fig. 9 ).
1.- Turn the wingnut screw (15) counterclockwise until the screw backs out from the hole.
2.- Remove the wingnut screw and pull down the latch (12) to release the shaft blades(9).
3.- Using one hand, hold the Mixing blades (8) inside the hopper and with the other hand Pull out completely the mixing blades shaft
(9) from the mixer-grinder.
IMPORTANT: Never pull out the drive shaft without holding the mixing blades. This could make
the mixing blades fall down hitting the hopper!
4.- Remove the mixing blades (8).
