10
MIXER GRINDER
KMG-32
2. Replace the knife and plate when assembly becomes loose even though the Ring (7) is totally tight.
3. If the power cord (25) or the plug is damaged, they must be replaced by an authorized service technician or qualified personnel
to avoid risk of electric shock.
4. To avoid any risk of short circuit and prevent the introduction of moisture or food waste, the membranes of the buttons (23) &
(24) should be checked daily and replaced if they are broken or have some damage.
STAINLESS STEEL SPECIAL CARE
This is a guideline of Cleaning methods for Stainless steel
Requirement
Suggested Method
Routine cleaning of
light soiling
Wash with Soap or detergent in warm clean water. Apply with a clean sponge, soft cloth or soft-fiber
brush then rinse in clean water and dry.
Fingerprints
Use Detergent. Rinse with warm water. Dry totally
Watermarks
Use clean rinsing water, such as reasonable quality potable (tap) water. Drying marks may be avoided
using an air blower or wiping with clean disposable wipes.
Grease marks
Use clean rinsing water , you could add white vinegar or soft water solution. Rinse with warm water
again and dry.
Rust stains
Wash surface with CLR (calcium, lime & rust remover) type cleaner. Use not acid and recommended
solution. Apply using a soft non-abrasive
sponge. Rinse surface thoroughly with clean soft water after application.
Dirt and debris
Wash surface with a mild liquid soap. Apply using a soft, non-abrasive cloth. Rinse surface thoroughly
with clean soft water.
IMPORTANT!:
If the machine is used inside rooms where the temperature is below than 32
°F (humid
environments), it
´s important to consider lubricating the transmission chain at least every 3
months. A good lubrication will reduce the chains stretch or kink up due to wear and corrosion
wear inside the pin and bushing area.
Apply lubricant (type SAE20 up to 50) manually using a brush. This procedure only can be
performed by a qualified technician.
VIII.- ELECTRICAL SPECIFICATIONS (depend on your equipment. See the Identification Plate ).
Equipment
Voltage
Current
Frequency
Capacity
Mixer Grinder
380/440 V3 ~
11 A
50 / 60 Hz
5,6 kW (7.5 HP)
220 V3 ~
21.5 A
60 Hz
5,6 kW (7.5 HP)
230 V3 ~
25 A
50 Hz
5.6 kW (7.5 HP)
220 V3 ~
28 A
60 Hz
7,4 kW (10 HP)
230 V ~
26 A
60 Hz
3,7 kW (5HP)
WARNING!:
The cabinet for this equipment must be opened by qualified personnel only.
For any problem or doubt related to electric specifications and connections, please call to
your authorized dealer.
