Printronix P4280, Maintenance Manual

Page: 209 / 298

6–41 Optional Equipment
6. Install the CT/IGP–2X0 power board (P/N 155018) on the bottom of the
card cage: (See Figure 6–12.)
a. Align the slots in edges of the power board with the studs on the
bottom of the card cage. Slide the board into position on the
studs so that the cable from the board points toward the front of
the printer.
b. Install the screw securing the power board to the bottom of the
card cage.
7. Tie–wrap the cable from the CT/IGP–2X0 power board snugly into
position:
a. Route the cable straight across the bottom of the card cage and
remove the slack.
b. Hold the cable vertical against the front edge of the card cage,
remove the slack in the cable, and install two tie wraps. Make
sure the part of the cable covered by the heat–shrink tubing is
under the tie wraps.
Mounting Stud
Tie Wrap
Card Cage
CT/IGP–2X0
Power Board
(P/N 155018–001)
Tie Wrap
Heat Shrink Tubing
Figure 6–12. Installing the CT/IGP–2X0 Power Board