Printronix P4280, Maintenance Manual

Page: 203 / 298

6–35 Optional Equipment
•
CT Config
Prints CT board firmware part numbers, version, and current switch
settings.
•
Print Error Log
Should be run and cleared with printout saved in printer’s log. Can show
various conditions degrading over time, such as paper jams, etc.
•
Translation Table
Used to check for valid characters in debugging graphic check errors.
Clearing the Error Log on CTPC Tests
The Error Log records the number of times each error occurred in the printer
since the last time the Error Log was cleared. The Error Log can be cleared
only after it is printed.
1. Press the FUNC switch and the CANCL switch to clear the Error Log.
2. The LCD shows the following message for one to two seconds:
PRINT ERROR LOG
STOPPED
This ends the test.
To exit the Print Error Log test without clearing the error log, press TEST/
ENTER.
NOTE: The values of the POWER ON HOURS and LINES PRINTED in
the Error Log printout will not be cleared. The Clear Error Log
feature only clears the Error Code and Error Messages on the Error
Log printout.
Clearing Correctable and Overrideable Errors
To clear Correctable and Overrideable Errors, refer to the error message
tables and follow the instructions. After clearing the error, complete the
procedure as follows:
1. Press the ENABLE/HOLD switch after the error is corrected to return
the printer to the HOLD state.