19
Validator Action
ODV-2D > Control > Validator Action
The printer response is the same whether the error stems from a bad or
missing bar code. It is determined by the Validator Action setting. See Vali-
dator Action (Error Action) for more details on each one of these options.
Stop
If the validator detects a bar code failure, the print job
stops.
Overstrike
Use Overstrike mode when you want bad labels to be
marked, but not reprinted.
Retry Form
This mode is similar to the Overstrike mode. However,
instead of resuming printing where the printer had left
off, the printer will attempt to reprint the bad form.
Stop & Retry
The printer will stop printing and display the error
message. After the error message is cleared and the
appropriate labels are skipped from
ODV-2D > Control
> Skip Labels
, it will reprint the bad form and any other
forms printed prior to the physical stop.
Grade&Report
The entire print job will print uninterrupted. If one or
more errors is detected, the printer status indicator
lamp flashes, the alarm sounds, and the error mes-
sage “Bar code fails / Job has errors” displays
.
Rescan Form
Similar to the Retry Form mode, however, instead of
backing up and overstriking the form, the printer will
back up and rescan the bad form and any other forms
that have already printed.
Rescan&Retry
Similar to Rescan Form with one exception: after the
printer has rescanned the form and overstruck it if
there was still a fault, it will reprint and rescan the
same form again.
Rescan&Stop
Similar to the Retry Form mode, however, instead of
backing up and overstriking the form, the printer will
back up and rescan the bad form and any other forms
that have already printed.
Factory Default
Retry Form
