Princeton Truck Mounted Forklift, Operator'S Manual

Page: 73 / 194

A4. OPERATING PROCEDURES
65
Basic Load Techniques
Traveling Without a Load
Always extend the mast fully forward.
Keep the forks as low as possible.
Never travel with mast back and no load.
WARNING:
No Load.
When traveling without a load the mast
MUST always be fully extended.
Traveling With a Load
Keep the mast fully retracted when traveling.
Lower the stabilizers fully before extending the mast
to place a load.
When lifting a load, keep the stabilizers fully
lowered until the mast is fully retracted.
Keep the load as low as possible.
Using Stabilizers
WARNING:
Stabilizers . When placing a load, always place the load
on a firm and level surface. The stabilizers must always
be fully lowered before attempting to extend the mast.
When lifting a load, the stabilizers must be fully
lowered and raised only when the mast is fully
retracted. When traveling without a load, the mast
should be extended fully.
DANGER:
Stabilizers.
Never raise the stabilizers when the mast
carriage is extended with a load on.
Note:
When the ground is not firm enough to support
the stabilizers extra support plates must be used of
sufficient size and strength to ensure they do not sink,
bend or buckle during operation. A second person may
be required to check the support plates. If at any time
the stabilizers or pads show signs of sinking, the
procedure must be stopped immediately, the mast fully
retracted and an alternative location found. If in doubt
prior to or during an operation on loose, uneven or soft
surfaces, stop. Always consider safety first.