Princeton Truck Mounted Forklift, Operator'S Manual

Page: 63 / 194

A4. OPERATING PROCEDURES
55
Engine Checks
The Temperature Gauge also has a MIL (Malfunction
Indicator Lamp). This will activate if faults are found
on the engine
If a constant red warning MIL is activated, then this is
an indication that there is an engine fault and a code
will be displayed on the gauge. It is safe to continue to
use the machine in this state but the engine should be
examined at the earliest opportunity.
If a flashing red MIL is activated the engine must be
turned off immediately.
Note: IF THE MIL IS FLASHING, TURN OFF THE
ENGINE, NOTIFY YOUR SUPERVISOR AND HAVE IT
INSPECTED AND REPAIRED.
There are a number of operator messages displayed on
the gauge as follows:
PAUSE – Engine temperature is to low and engine
revs
are restricted until sufficient engine
temperature has been reached.
PEDAL – Engine has come out of “PAUSE” mode,
accelerator pedal must be released to the neutral
position and re pressed to allow the operator to rev
the engine.
FUEL – Water in the fuel system, check water
separator (See section 7 Special Procedures)