Princeton Truck Mounted Forklift, Operator'S Manual

Page: 62 / 194

A 4 . OPERATING PROCEDURES
54
Starting the Engine
Start Safely
Adjust the seat and fasten the seatbelt. Ensure all
operating controls including the pedal and hydraulic
levers are in the neutral position before starting. Alert
all people in the area before starting the machine.
When starting your equipment in an enclosed space,
make sure that there is adequate ventilation.
WARNING:
Engine Damage. Do not use starting fluid or spray as
these are highly flammable, corrosive and cause engine
damage.
Insert the key in the ignition. Turn the key clockwise to
the start position, depress the accelerator pedal until
the starter engages and the engine starts. Do not
engage the starter for any more than 15 seconds at a
time. Release the key and it automatically returns to
the on position. If the engine fails to start, turn the key
to the stop position for 1 minute and repeat the starting
procedure.
After starting, check that all red instrument panel
warnings lights have gone out and that all gauges are
functioning properly. If all red warning lights have not
gone out or illuminate during operation, stop the engine
immediately.
Do not attempt to operate the Truck Mounted Forklift
with a warning light on as serious damage could occur
to the engine.
During engine start-up, the engine RPM may be
restricted by the ECU for a time based on the engines
temperature. The word “PAUSE” will be displayed on
the temperature gauge during this period.
After Start - Up
Run at minimum engine speed for a short period
according to the table below.
Engine Temperature Time
•
14°F 10 seconds
From 14°F to -4°F 30 Seconds
”
-4°F 60 Seconds
Do not turn off the engine when it is running at
maximum speed.
Before turning off, allow the engine to idle at minimum
speed for 1 minute before turning the key to the off
position.