625-525revG-EN
9
Printed in USA 4/06 © 2006
Steamer
625-OS
Cleaning — Daily PM Tasks
Turn the unit off and unplug the power cord from the electrical
receptacle. Proceed with caution, unit is still hot!
This unit is not watertight. Do not clean with a water jet/jet spray. Do
not immerse the unit in water.
Do not use abrasive materials such as scrapers, steel wool, etc. to
clean the spatula or steam chamber.
WARNING
CAUTION
While wearing protective gloves, remove the top cover by pulling
up and off the unit.
1
Top Cover
A. Wash top cover, top plate, and venturi plate in a solution of
McD
®
APSC / APC made up in the back sink.
B. Rinse with clean water, and then sanitize in a solution of
McD
®
Sink Pak Sanitizer.
C. Let air dry.
3
Use brushes to clean the water tube. Dip the brush in warm water
or deliming solution. Insert the brush about 1" into water tube and
then remove. Repeat for 30 seconds.
5
Insert Brush Here
The following tools are required:
•
McD
®
All Purpose Super Concentrate (APSC)
•
McD
®
Sink Pak Sanitizer McD
®
APC
•
McD
®
Delimer™
•
Clean sanitized towel
•
Protective (insulated) gloves
•
Steamer brush
•
16 oz (437 ml) cup
A. Remove spatula with
insert.
B. Remove the top plate
by carefully sliding it
forward and out of the
unit.
C. Remove the venturi
plate.
While wearing protective gloves:
2
Top Plate
Venturi Plate
Spatula
Spatula Insert
OPTIONAL: If the surface shows
signs of excessive calcium and
lime buildup, dissolve two
teaspoons (10 ml) of McD
®
Delimer™ in a small coffee cup
with 100 mI of water. Pour half on
each side.
Allow to sit for 5 minutes. Using a
clean sanitized towel, thoroughly
rinse and wipe the internal
surfaces of the steam chamber.
4
Wipe the steam chamber surface with a clean sanitized cloth.
Wash all external surfaces of the steamer with a solution of McD®
APSC / APC. Using the McD
®
APSC / APC spray bottle, spray
directly onto a clean sanitized towel and wipe the unit clean.
6
Do not spray directly on the unit or use abrasive cleaners!
Reassemble the unit.
Turn the unit on. When unit is preheated, run a minimum of four cycles to
prime the unit and remove any residual cleaner.
CAUTION
Deliming
It is recommended that the steamers go through a deliming procedure at least once a month. Some hard water areas may require daily,
weekly, or biweekly deliming based upon actual buildup.
