Primera RX900, User Manual

Page: 27 / 76

Using RFID
23
Advanced Options. Access advanced options by clicking
the icon on the top right side of the status monitor. Click
the options button.
Print 'XXXX' on RFID Failure .
By default a series of XXXXs will
automatically be printed on the
label to indicate that it was not
encoded properly. If you disable
this option nothing will be
printed on an encoding failure.
Feed Speed. This is the speed that
the label stock will feed when it
is NOT printing. You may need
to decrease this value if there is
very little information being
printed on a larger label. It is
possible that the printer prints so
fast that the loop system cannot
keep up and maintain a slack
loop. If this happens the labels will slip in the printer.
Decreasing the speed minimizes the likelihood that the loop
sensor will not be able to keep up and maintain a loop.
Maintenance Every. This sets the interval for maintenance
between labels. Maintenance means that the print head moves
all the way to the right and the labels back feed slightly so the
wiper can wipe the nozzles clean. Increasing the interval will
decrease print quality but improve speed.
Present Delay. Delay in seconds after last page is printed
before label is presented for tear off. Adjust higher if labels are
presenting between pages. This is most likely to occur if you
send separate prints queued one after another.
Unpresent Time. This is the time between the finish of the print
and when the printer moves the stock back into position for the
next encoding/printing. The purpose of this setting is to allow
a specific amount of time to remove the label after a one off
print.