Primera RX900, User Manual

Page: 12 / 76

8
Label Stock
If you are printing in continuous or reflective label sensing mode
number 2 does not apply. The fact that the printer must read through
the backing in die-cut mode will limit the thickness much more than
the printers ability to pull the paper through the print area. However,
if you adjust opacity level of the liner enough to allow the label to be
seen by the stock sensor, the thickness will only be limited by the
printers ability to pull it through the printer area. For these reasons
the weight or thickness of the liner is a variable that can not easily be
defined. Primera recommends and uses 40# liner with all label stock.
It is important to test all label stock with the intended printer
before ordering large quantities!
Roll Specifications
Note on Label Orientation:
If you are using an applicator to
apply your labels, be sure to order label stock with the correct
orientation for your applicator. For example most applicators will
apply the side of the label first, so you will want to print the labels
sideways.
Label Side Out
Core I.D.
Core O.D.
Roll O.D.
3” 6”
Label Stock