Label Stock
15
Caution:
The gap between the Throat Guides should be narrow enough to accurately
guide the label stock but not narrow enough to pinch the label stock. (The gap
should be .016" - .032" [0.4 - .08mm] wider than the label stock.) If the label
stock is pinched by the guides, poor print quality or feeding problems could
result.
9. Feed the label stock further into the printer until it senses the label
and automatically feeds it through the printer.
Caution:
There should be no exposed adhesive at the edges of die-cut labels. It will
cause labels to stick to each other and cause adhesive build-up along the printer
path inside the printer. This adhesive cannot easily be cleaned without disas-
sembling the printer. Do not feed label stock into the printer that seems to stick
to itself as it is unwound from the roll!
Note:
If the printer fails to feed the label stock, press the Load/Feed button on the
front panel while continuing to guide the label stock into the printer.
