XTR-PX2-C0006-IN004
3-7
4.
Use the Lift jig to lift the PILLAR up with 5-cm (2-inch) increments in gradually.
Checking that the SENSOR BASE does not tilt (the projection of the SENSOR BASE does not come in
contact with the sensor), securely tighten the screws of the SENSOR BASE.
The SENSOR BASE fixed at a tilt will hit and break the photo interrupter attached on
the back of the PILLAR.
Pay careful attention to perform the installation.
<How to use the Lift jig>
The projection of the SENSOR BASE
shall not come in contact with the
sensor.
CP5X12-I3-CM1
(Securely tighten)
Power switch
Up: ON
Down: OFF
Hoisting direction
Left: Move up
Right: Move down
Operation switch
