5.17 Elliptical Fitness Crosstrainer
Page 29
Diagram 6.1 - Supporting the Ramp
Diagram 6.2 - Lift Motor Mounting
8.
Remove the screws that secure the cover support bracket and remove the cover support
bracket.
9.
Disconnect the lift motor cable from the lift motor interconnect cable.
10. Grasp the ring on the clevis pin and pull the clevis pin out of the lift motor. Remove the lift
motor. Do not allow the lift motor nut to rotate on the lift motor. If the lift motor nut rotates the
lift motor must be re-calibrated per Procedure 4.1, steps 4 and 5.
11. Remove and replace the rear cover.
12. Set the lift motor at it’s mounting position and insert the clevis pin.
13. Remove the bungi cord from the ramp and set the ramp at it’s mounting position. Do not
rotate the lift nut any more than is necessary to align the holes in the lift nut with the holes in
Retaining Clips
Lift Nut Mounting Pin
Lift Nut
Lift Motor
Clevis Pin
Cover Support Bracket
Lift Motor Cable