5.17 Ellipitical Fitness Crosstrainer
Page 42
Procedure 6.9 - Replacing the Lift Motor
Removing the Lift Motor
1.
Set the on/off switch in the “off” position. Remove the six screws that retain the front half
front cover to the rear half of the front cover and remove the front half cover.
2.
Remove the retaining clip from each lift nut mounting pin. Support the lift ramp assembly
and remove the lift mounting pins from the lift nut. Raise the ramp and support it from the
handlebars using a bungi cord (See Diagram 4.1).
Diagram 6.8 - Lift Motor Mounting
3.
Disconnect the lift motor cable from the lift motor interconnect cable.
4.
Grasp the ring on the clevis pin and pull the clevis pin out of the lift motor.
5.
Remove the lift motor from the EFX.
Replacing the LIft Motor
6.
Set the replacement lift motor at it’s mounting position and replace the clevis pin.
7.
Connect the lift motor cable to the lift motor interconnect cable.
Lift Nut Pin
Lift Nut
Retaining Clip
Lift Nut
Lift Motor
Drive Screw
Lift Motor
Clevis Pin
