ConsoliDator Multi-Channel Controller
Instruction Manual
22
Main Setup Menu
The main setup menu is the
access point during the
programming process for setting
up
Inputs, Outputs,
and
General
Functions
. The number of inputs
and outputs shown on this screen
are determined by what your
particular model is equipped with.
Use arrows to navigate and the
ENTER
key to select.
Inputs
Outputs
EXIT
ENTER
Alarm Relay #1
Alarm Relay #2
Alarm Relay #3
Alarm Relay #4
Alarm Relay #5
Alarm Relay #6
Alarm Relay #7
Alarm Relay #8
Alarm Relay #9
Analog Out #1
Analog Out #2
Channel #1
Channel #2
Channel #3
Channel #4
Channel #5
Channel #6
Channel #7
Channel #8
Flow Meter #1
Flow Meter #2
Flow Meter #3
Flow Meter #4
Buzzer: ON OFF
Change Password
Save BL: YES NO
Baud Rate: 19200 bps
Parity: EVEN - 8E1
Modbus ID: 1
Tx Delay: 0 ms
Adjust Contrast
T-Out: ON OFF
Inputs
The
Inputs
box shown on this screen lists the 4-20 mA Channels and Flow Meter inputs.
Individual channel setup is covered in detail in the next sections:
Configuring 4-20 mA
Input
(page 24) and
Setting Flow Meter Pulse Inputs
(page 30.)
Outputs
The
Outputs
box shown on this screen lists the relay and analog output channels available.
Output setup is covered in
Programming Relays
(page 31) and
Setting 4-20 mA Outputs
(page 40.)
General Functions
The
General Functions
box contains various options and serial communication settings.
If you are beginning a first-time setup, please read the brief descriptions below and if you are not sure of
the settings, you may skip them and return after the controller’s operation is explained in later sections.
Use the arrows keys to move cursor to parameters in the
General Functions
box. Use
ENTER
to select a parameter.
Buzzer
Buzzer sounds to indicate an active relay if [ON] is selected. Select [OFF] to disable.
Time Out
Manual mode time-out options are related to
Manual and Simulation Modes
(page 45.) When
T-Out
is set to [ON] the controller will return to Automatic mode after
being left alone for 5 minutes in Manual mode. When [OFF] is selected, the controller
will only switch modes if a key is pressed and then the password (if enabled) is
entered.
Password
Select [Change Password] to enter a new password up to ten characters or to change
an existing password. The operator will be required to enter this password to access
setup or to manually override relays. It is recommended to enter the password after
setup and programming is completed.
To disable a previously programmed password: Enter setup, select [Change Password] and leave
the
Password
entry box blank.
