pratic Pergola STIl, Original Instructions Manual

Page: 13 / 32

PAG. 13
Pergola
Stil
- Manuale di installazione
Rev. 02/18
Installation of the awning
9. Fix the guides (24) to the U bracket (87) into the space that has been created between the couple of the
beams without clamping completely the screws (scheme M).
10. Check the perfect alignment of the slides on all the guides (scheme P, then You can proceed with the
installation of the motor on the wall or on a current profile according to the cases (scheme Q, R) taking
care to respect the precise alignment of the transmission axes. Insert the caps into the transmission
tubes diameter 40 mm and install the transmission on all the fields of the awning. Regoulate properly
the square pivots and at the end please, close the screws of the caps in order to block definitively the
pivots (scheme S).
11. In case of motor safety Box which has been installed on a current profile, it will be necessary to forecast
a current profile for the field where You intend to put the motor (scheme R).
12. Fix the profiles (which have been previously coupled with the fabric) to the guides passing through (a
profile at a time) the pivots of the slides in the suitable hole using the new patented system Clic System
for the terminal fastening and the delrin security bush for the intermediate fastening (schemes T, U, V).
Caution : before closing the lower cover of the front tap, be sure to have inserted the related security
bush with a coupling snap (scheme V).
Caution : In case of structures with packed slack fabric, it will be supplied a spacing slot band per each
guide which will be inserted in the slides (between the small neopreme gum and the same slide) before
engaging the profiles.
13. Let the awning run opening and closing a couple of times.
14. Regulate the end-run of the motor (please see the enclosed instructions of the motors)
Caution : Read the instructions and the electric schemes related to the motors very carefully.
15. The connecting bracket of the pocket (3/T o 3/NT) will be fixed to the wall support; No Tasca version use
bracket (3/NT), Con Tasca version use bracket (3/T) (scheme [W]).
16. In case of winch is mandatory Con Tasca version(3/T); and drill a cut in the closure pocket for teh pass of
the rod (scheme [X]).
Roof and Top cover beams
17. Fix the top cover beams on the couples of beams in order to protect the profiles and the guides (scheme
X). The top cover beams will be supplied in more pieces of 110 cm to be surmounted in ascendant
direction (like the roof tile).