pratic Pergola STIl, Original Instructions Manual

Page: 12 / 32

PAG. 12
Pergola
Stil
- Manuale di installazione
Rev. 02/18
INSTALLATION INSTRUCTIONS
Width to cm. 700
Side guides of the structure (24) with polyamide slides (5) (6) (7), stop-slide (30), polyurethane driving belt
with stainless steel pins (17), pulleys (8) and cases (9) already assembled.
Front bar (22) inter-ties (23) and coupled fabrics.
Width over cm. 700
Side guides of the structure (24) with slides (5) (6) (7), stop-slide (30), polyurethane driving belt with stainless
steel pins (17), pulleys (8) and cases (9) already assembled.
The profiles will be supplied in more components to be assembled through suitable joints.
Couple the profile of the inter-ties windbreaks, passing the PVC profile (27) welded on the fabric inside the
proper slot of the aluminium profiles (scheme A, B).
Insert the closure pocket and the related profile of the canopy according to the scheme A which has been
recorded in the next pages; Close the profiles sideways with the taps (28) (29) and tension the fabric through
the relative screws (scheme D); Drill holes 10 mm diameter with care on the fabric according to the holes on
the aluminium profiles (schemes A, E) in order to allow the insert of the slides ‘ pivots later.
Caution : drill the fabric only after having coupled it to the profiles (taking care not to damage the hooking
system of the tap).
Caution : In order to allow a better sliding of the tubes along the seats into the profiles it is advisable to
apply Silicone Protective Detacher on the same small tubes.
Operations:
1. Open the package with care, in particular do not cut the fabric and do not scratch the paint of the
aluminium.
Assembling of the aluminium structure:
2. Apply the wall plate according to scheme and to the indicated interaxis in the first page of the installation
instructions.
3. Couple the beams in groups of two pcs. and fix to them the wall plate (86) with relative centring bushes
which are already jointed; Insert all the TE M 10 screws suitable for the fixing of the intermediate U
bracket (87) into the proper seat, without clamping completely the screw nuts (schemes F, G).
4. Insert the positioning plates completes of M10 dice, screws M10 and security hook.
Place them at the required distance (scheme H) and clamp firmly the dice M10.
Caution:pay attention the the side of the positioning plates.
The indicated quote referes to a structure with purlins that tranship to the gutter 19 cm. (scheme L)
In the case of gear, it is advisable to install immediately the gear unit(90) (without the drive pin) on the
suitable purlin (scheme I) teh gear must be installed in the inside part of the structure.
5. Set the caps (98) on the front pulrins.
6. Fix the ground brackets (141) on the front posts profiles. Build the front frame inserting and fixing the
supporting gutter to the brackets (121 and 122) of the front posts with the proper screws and small
plates (scheme K)
Caution: we advise to put silicon in all the joints of the gutter.
7. Install the beams already coupled, fixing them backward to the wall support plate and rest them frontly
to the front brackets (122). Insert the screws TE M10 of the positioning plates in the appropriate slots
of the front brackets(122). Fix the security hooks to the TBEI M screws and clamp firmly the screws.
(scheme L)
8. Check the levels, the squaring and all the sizes of the structure; at the end, clamp firmly all the screws.