Pramac Pmi3000, Operator'S Manual, Page: 16 / 153

13
5.3 Use of DC
The output voltage is DC 17-30V when the DC socket is carrying idler. Only for the charging of
12V automatic battery.
The output current of DC socket will change according to the different position of the SMART
switch.
DC current:
SMART SWITCH
Model
OFF ON
(No AC output)
Pmi3000 8A about 6-7A
1. Connect the generator DC socket with the battery terminal for charging current.

Do not try to start the engine when the generator is still connected with the battery.
The generator may be damaged.

Do not confuse the positive and negative when connecting the charging cable
positive and battery positive. Otherwise the generator and battery may be seriously
damaged.

To avoid sparks besides the battery, please connect the charging cable to the
generator first, then connect the battery. The disconnection should start with the battery.

Please disconnect the battery ground wire before connecting the charging cable to
the auto battery. It will avoid the short circuit or spark if you touch the auto frame with
battery terminals accidentally.

The green and red lights may be on together when the generator is just started.
Normally the red light will be off after 4 seconds. If the red light is still on, please contact
PRAMAC service.