ITX 3000/2000 Printer User Manual
(UMITX315.PDF
)
Page 21 of 82 Date: 4/27/05
4.5.2.4
System Information Help Report
The report above has a second part. If the [F0] switch is held after the first part has completed printing, the system information
help report will also be printed. This report is a collection of menus (which are printed during the associated operating modes)
and general help for other printer information such as error codes, etc.
**************************************
* OFFLINE SW. HELP *
**************************************
F0/SEL
= ON/OFFLINE Toggle
F1/TST
= Print TEST ticket
F2/LF
= Line FEED Paper
F3/FF
= FORM FEED Paper
F0 & F1
= CUT PAPER
NOTE: A warning BEEP/FLASH will
occur every 15 sec when in
the off-line condition.
**************************************
* POR SWITCH HELP *
**************************************
Apply power to unit while holding:
F0
= SYSTEM STATUS
F1
= DIAGNOSTICS
F2
= NOT USED
F3
= EEPROM MENU
F0 & F1
= RE-PROGRAM FLASH MEMORY
F0 & F2
= PRINTHEAD CLEANING
(F0/F1=Fwd;
F2/F3=Rev)
F2 & F3
= HEX DUMP MODE
**************************************
* EEPROM ENTRY HELP *
**************************************
Turn off power to printer.
Hold F3 while turning on power.
Hold F3 until 1st beep.
Release F3, wait for second beep.
Press F3 twice quickly, hold
press until printing starts.