49. the serial number is a unique production number of the unit and is pro-
grammed only once by Pc. if you try to change it, is displayed:
Invalid Serial
Number!
to restore the factory settings it is needed at power up to place a jumper be-
tween the two middle terminals of the connector "Prg": the 5 leds for the level of the
GsM signal and the remote led “
Status
” go on for about 0 seconds. the jumper is
necessary only at power up; after that it is removed.
Configuring by SMS
to restore the factory settings it is needed at power up to place a jumper between the
two middle terminals of the connector "Prg": the 5 leds for the level of the GsM sig-
nal and the remote led “
Status
” go on for about 0 seconds. the jumper is neces-
sary only at power up; after that it is removed.
. When configuring by sMs use the same two-letter commands written in
lower case. the distinction between the commands and also between data in one
command becomes with comma, no spaces. the manner of arrangement of individu-
al commands does not matter, important is just to begin with "
code =
" and the correct
configuration code, and ends with "
go
". if at the end there is a number to which the
module to send an sMs with the content of the configuration parameters, the sMs
must to end with a period "
.
" for the end of the number.
. as the maximum size of the sMs, sent from the module to the user is 60
characters, it may be required the following areas of the data:
- rds: status of the panel:
system arMed , zones: annann, ac Power on
system disarmed, zones: nannnn, ac Power off
- rd0: alarm parameters: entry delay "ed"[d], exit delay "xd"[d], Zones type
"zt"[d], Bell time "bt"[d], Zones delay "zd"[d], Zones activity "za", chime delay "cd",
ac trouble delay "at", ac restore delay "ar", alarm codes Mode "am"[d], GsM re-
port options "gr”[d].
ed=0,30,00,00,00,00 xd=90 zt=7,0,0,03,04,05 bt=60
zd=0,0,0,0,0,0 za=00,0,0,03,04,05 cd=0 at=30 ar=05 am=09
gr=00,0,00,0,00,00
all parameters are in decimal form
-rd: Zones description: by 4 characters
:Zone vhodna vrata :Zone Koridor 3:Zone3 Hol 4:Z4 spalnya
5:Z5 Goren etaj 6:Zone6 Predverie
-rd: GsM numbers and number for the limit of prepaid card and GsM Mode
options "
gm
" [h]
