16
4.2 Input and Output Power Cords and Protective
Earth Ground Installation
1. Notes for installation
1)
The UPS must be installed in a location with good ventilation, far
away from water, inflammable gas and corrosive agents.
2)
Ensure the air vents on the front and rear of the UPS are not
blocked. Allow at least 0.5m of space on each side.
3)
Condensation to water drops may occur if the UPS is unpacked in a
very low temperature environment. In this case it is necessary to
wait until the UPS is fully dried inside out before proceeding
installation and use. Otherwise there are hazards of electric shock.
4)
Once the installation is completed, the side mounting brackets
（
used in shipping
）
shall be fixed back to ensure the stability of the
UPS enclosure. If impossible, additional stability can be added by
anchoring the mounting brackets to the floor with M8 bolts. See Fig.
4-5.
（
only for PowerWalker VFI 10000-20000 TP 3/1
）
Fig. 4-5 Additional stability
2. Installation
Installation and wiring must be performed in accordance with the
local electric code and the following instructions by professional
personnel.
Summary of Contents for VFI 10000TCP 3/1
Page 12: ...9 PowerWalker VFI 10000 TP 3 1 REAR VIEW PowerWalker VFI 20000 TP 3 1 REAR VIEW...
Page 35: ...32 Fig 5 14 Main menu tree...
Page 67: ......
Page 103: ...und Einstellungen...
