23
Jamb Nut
12.
Align drive chain to the drive
sprocket and ensure it is parallel to
gate using slots in gate bracket as
shown below.
NOTE:
If required, reposition drive sprocket
by loosening set screws and relocating drive sprocket on
operator drive shaft. Tighten set screws after desired
location is obtained.
NOTE:
By moving the gate manually to each end of its
travel, chain alignment is simplified.
5/16" Hex Key
Hand Crank
Cordless Electric
Drill With 5/16"
Hex Key Bit
Lift Interlock lever
To Expose Drive Hub
OR
13. Adjust chain tension so that the
chain tension springs are
reduced to a length within 1-
7/8” and 1-3/4”.
Adjust Spring Length
As Shown For Proper
Chain Tension
24
ELECTRICAL CONNECTIONS
WARNING
- DO NOT APPLY POWER UNTIL TOLD TO DO
SO. RISK OF SHOCK OR INJURY MAY RESULT!
NOTE:
Wiring to operator must use watertight materials in
accordance with local electric code. See wire gauge/distance
charts for proper sizing. Master/Slave installations should have
SEPARATE
power supply wiring or length of wire runs should
be figured at half that shown on the chart.
This unit must be
grounded in accordance with N.E.C. and local codes.
Before connecting the operator, use a voltmeter to determine
that the electrical service is 115V. THIS OPERATOR CANNOT
BE CONNECTED AT 230 VOLTS. Damage will result which is
not covered under warranty.
Line
Voltage
HP
14
AWG
12
AWG
10
AWG
8
AWG
6
AWG
115
VAC 1/2 150’ 250’ 400’ 500’ 650’
L O W V O L T A G E W I R E
G A U G E / D I S T A N C E C H A R T
2 4 A W G : U p t o 1 5 0 '
2 0 A W G : 1 5 0 ' - 2 0 0 '
2 5 0 ' - 1 , 5 0 0 '
C o n t r o l w i r i n g s h o u l d b e r u n a s t w i s t e d
p a i r s . D O N O T r u n c o n t r o l w i r e s i n t h e
s a m e c o n d u i t a s p o w e r w i r e s . t e l e p h o n e
w i r e s , o r l o o p d e t e c t o r l e a d s .
1 8 A W G :
