Med Touch Series LCD Alarm Systems
Powerex
•
150 Production Drive
•
Harrison, OH 45030
•
USA
P 1.888.769.7979
•
F 513.367.3125
•
www.powerexinc.com
IN597400AV
•
08/2016
Page 32 of 56
The following additional commands are available for reviewing and testing:
SCx
(show contact) – this command is used to verify the contact entry. For example - SC2 would display the contact entry for user #2.
MCx
(test command) – this command is used to verify that a contact and e mail server is set up correctly. It sends a test e mail to that contact.
Following is a complete list of the available commands:
All commands are issued from the command prompt over the serial port. Set the PC’s serial port to 9600 8N1.
Boot the rabbit board.
INIT // INIT SETUPS.
!!! IMPORTANT !!! This MUST be run first on a new board or after battery replacement. Usage: INIT
SIP // SHOW IP. SPN // SHOW PANEL NAME.
SMB // SHOW MODBUS ID. SMI // SHOW SMTP MAIL SERVER IP.
SUN // SHOW USER NAME. SUP // SHOW USER PASSWORD.
SDT // SHOW DATE/TIME. SAL // SHOW ALARM LOG.
SGW // SHOW GATEWAY. SCx // SHOW CONTACT.
Usage: Enter the command as shown.
SCx // SHOW CONTACT where x is contact number 1-5. Usage: SC1 will show email contact 1 of 5.
PPN // PROGRAM PANEL NAME. Usage: PPNMyPanel will set the Panel Name to MyPanel.
PMB // PROGRAM MODBUS ID. Usage: PMB01 will set the Modbus ID to 1.
PDT // PROGRAM DATE/TIME. Usage: PDT0129160842 will set RTC to Jan 29th, 2016 at 8:42am. PDT0203162042 will set rtc to Feb 3rd, 2016
at 8:42pm.
PIP // PROGRAM IP. Usage: PIP192.168.0.50 will set the rabbit board IP address to 192.168.0.50
PGW // PROGRAM GATEWAY. Usage: PGW192.168.0.1 will set the gateway IP address to 192.168.0.1
PMI // PROGRAM SMTP MAIL SERVER IP. Usage: PMI192.168.0.50 will set the SMTP mail server to 192.168.0.50; PMI will clear the SMTP mail
server.
PUN // PROGRAM USER NAME. Usage:PUNMyUserName will set the SMTP user name to MyUserName; PUN will clear the user name.
PUP // PROGRAM USER PASSWORD. Usage:PUPMyPassword will set the SMTP password to MyPassword, (Case Sensitive); PUN will clear the
password.
PCx // PRGRAM CONTACT where x is contact number 1-5. Usage: [email protected] will set contact 1 to [email protected]; PC1 will
delete the contact.
MCx // MAIL CONTACT where x is contact number 1-5. Usage: MC1 will send contact 1 a test email.
To setup a new Rabbit board
1.
INIT
2. PPNPanelName
3. PDT0129160842 replace with current date and time.
4. PIPx.x.x.x replace x’s with board’s IP address.
5. PGWx.x.x.x replace x’s with gateway’s IP address.
If SMTP mail server is to be used
1. PMIx.x.x.x replace x’s with Server’s IP address.
2. PUNMyUserName
3. PUPMyPassword (Case Sensitive)
4. [email protected] and/or [email protected]
up to 5 contacts total.
5. Use the show and test mail commands as necessary to check
setups.
