Med Touch Series LCD Alarm Systems
Powerex
•
150 Production Drive
•
Harrison, OH 45030
•
USA
P 1.888.769.7979
•
F 513.367.3125
•
www.powerexinc.com
IN597400AV
•
08/2016
Page 27 of 56
Programming the Ethernet/Rabbit Boards
(e mail/text messages, accessing alarm website, interface Modbus
with building automation system & access event log).
NOTE:
Networking options only work when used with manufacturer
supported software systems (currently Windows 7 or newer).
System router ports must be configured for ‘half duplex’.
To program the rabbit board, you will need to download Real Term:
Serial Capture Program.
This is a free software download available on the internet. You will
want to install the Real Term software on a laptop so that you have
the mobility to bring the laptop close to the alarm panel. You will also
need a 35-3033 rabbit board programming kit.
NOTE:
If your operating system doesn’t pull in the driver for the 35-
5069 cable, you must download the driver from the website.
http://www.ftdchip.com/Drivers/VCP.htm
Once you open the website scroll down to Currently Supported
VCP Drivers – the first box is Windows* - Comments – click on set-up
executable – than click on CDM21218_Setup.exe to install the drivers.
Always turn the power off to the alarm panel before making any
electrical connections or disconnections.
WARNING:
Uncoupling the rabbit board from the Ethernet board
(red and green boards in photo below) will result in loss of all of the
programming.
After the Ethernet kit is installed in the alarm panel and the Real
Term: Serial Capture Program software is installed on a laptop and
the 35-3033 rabbit board programming kit is connected properly, you
are ready to begin.
