Power Products TENERIFE, Instructions For Use Manual

Page: 44 / 106

E
sp
a
ñ
o
l
42
E
n
g
lis
h
P
o
rt
u
g
u
ê
s
E
sp
a
ñ
o
l
E
n
g
lis
h
P
o
rt
u
g
u
ê
s
4.2 Oil filling and checking .
NOTE: The generator is delivered without oil. Do not attempt to start the
generator without adding oil in the engine first!
The generator has to be on a perfectly flat surface and levelled, to avoid an error
in the oil level reading.
Open the small access cover for maintenance (located below of the exhaust pipe).
Remove the cap and put the oil into the engine through the hole, until reach
(without exceeding) the maximum limit (MAX) like shown in the figure below.
The estimated amount of oil to reach a correct level is 1.1 Liters.
Use good quality four-stroke engine oil SAE10W30 or SAE10W40.
Recommended oil classification must be API “SJ” (USA) or ACEA “A3” (EUROPA)
or more updated (see container specifications).
NOTE: The engine may consume a bit of oil during its running. Therefore,
before each usage, always check oil level and refill if necessary.
NOTE: Never use oils that are old, dirty, in poor condition or without
specifications (grade and quality). Do not mix different types of oils.